Electrical Engineering Design
We follow NEC and IEC standards for designing Power Systems for Residential, Commercial, and Institutional Buildings. These includes the following:
Design of Lighting System
- Determining the Lux levels for each classified area together with lighting controls requirements for power savings, for both indoor and outdoor lightings
- Light Fixture Layout Designing involving Normal, Emergency, Critical and Life Safety
- Light Fixtures Identification as per recommended Standards and Occupancy sensors, dimmers, etc., their selection and placement at appropriate locations
- Worst-Case Egress Lighting Estimations
- Lighting Load Estimations and determining numbers of feeders for Lighting Panel
- Lighting Distribution Panel design
- Switchgear Sizing
- Determining Transformer Size for Lighting Distribution systems
- Designing the Life safety and Emergency Panels
- Determining the Lighting Panel Location based on inputs provided
Design of Power System
- Determining the Receptacle, Electrical and Electronics equipments for all areas
- Determining the Loads for Electrical and Electronics equipments
- Determining the connected Load on each Circuits
- Power Distribution Panel design
- Determining Transformer Size for Power Distribution
- Designing the Life safety and Emergency Panel
- Determining Earth Protection requirements
- Switchgear Sizing
Design of Power Distribution System
- Determining Power and Lighting Load determination on the basis of actual connected equipment with appropriate demand/diversity factors, as per recommended standards
- Determining the Total Power Requirements
- Determining Power Factor Correction requirements
- Determining the Main Transformer requirements
- Determining the size of Generators
- Determining the HV equipments, metering and protective switchgear requirements
- Determining Cable Trays & Trenches and their optimum path
- Switchgear Sizing
- Determining the cable and wire sizing
- Determining the one line diagram for distribution systems
Design of Fire Protection System
- Determining the numbers of Circuits and device types according to defined areas
- Determining the Integration requirements with respect to Annunciation, Automatic Dialing and Building Management Systems
- Fire Detector, Enunciator, Manual Points and Panel Layout
- Control Diagram for Remote Panels and Main Panels
- Riser Diagram
- Device and Panel schedule
- Control Circuits for Integration with Building Management Systems
Design of PA/ACCESS CONTROL/CCTV
- Telecom room layouts
- Audio Video Systems Design
- Security Design like Access Control, Intrusion Detection and CCTV
- CATV
- Intercom
- Paging
- Clock
Customer Segment / Industry
Our typical Customer segment includes:
- Electrical consultants
- Architects
- Building Contractors
- CADD solution providers
|
Software
Some of the softwares in which we specialize:
- AutoCAD 2007
- Power suite
- Com check
- AGI 32
|
Input formats
- AutoCAD files (dwg, dwf & dxf)
- ADT files (dwg)
- All Images like TIFF, JPEG, etc.
- PDF files
- Scanned Images
- Hand Drawn Sketches
|
Output formats
- AutoCAD files (dwg, dwf & dxf)
- PDF files
- All Images like TIFF, JPEG, AI etc.
|
View Projects >>
|
